cecotec BOLERO DRESSCODE 7200 INVERTER Manual De Instrucciones página 30

ENGLISH
supply hose. Energy consumption will decrease automatically for some programmes. (Only for
some models).
Connect the water supply hose following one of the 2 methods:
- Connection between an ordinary tap and the water supply hose. Fig. 8.
- Loosen the clamp nut and four bolts.
- Tighten the clamp nut.
- Press and slide the hub and insert the water supply hose in the connection base.
- Connection finished.
Connection between a screw tap and the water supply hose. Fig. 9.
- Screw tap and water supply hose.
- Special tap for washing machine.
Connect the other end of the water supply hose to the inlet valve in the rear part of the product
and fasten the pipe tightly clockwise. Fig. 10.
Drain hose
Note
- Do not kink or extend the drain hose.
- Position the drain hose properly, at 60-90 cm from the floor.
There are two ways to place the end of the drain hose:
- In a drain pipe. It is recommended to use a vertical tube.
- In a sink drain pipe, over the trap.
Fig. 11.
If the washing machine has a drain hose bracket (depending on the model), it can also be
installed on a sink or a tank, as indicated next. Fig. 12.
Warning
When installing the drain hose, fix it properly with a rope or a clamp. If the drain hose is too
long, do not force it into the washing machine as it will cause abnormal noises.
4. OPERATION
Note
- Please make sure the appliance is properly installed before operating it.
- Before washing the clothes for the first time, the product shall be operated in a complete
washing cycle without the clothes inside.
58
Calibration
- It is recommended to calibrate the device. To do that:
- Empty the washing machine.
- Plug it in.
- Turn on the device and press Speed and Delay start at once for a maximum of 10 seconds.
The display will show "t19".
- Press the Start/Pause button to start the washing cycle. The display will show ****.
QuickStart
Before washing
- Plug the device into a power supply.
- Open the water supply tap.
- Load the washing machine with the laundry.
- Close the door.
- Add detergent (and softener if necessary). Fig. 13.
Warning
Detergent must be added in case I only after selecting the pre-wash for washing machines
with this function.
Washing
- Turn the device on.
- Turn the knob to select the desired programme.
- Select a function or use the default one.
- Press Start. Fig. 14.
Warning
If any of the default options is selected, step 3 can be skipped.
After washing
The appliance will beep, or the display will show "End".
Using the washing machine
Before each washing
- The washing machine should be operated within a temperature range of 0-40 °C. If used
under 0°C, the inlet valve and draining system may be damaged. If the machine is placed or
operated in rooms at 0°C or below, it should be transferred to normal room temperature to
ensure the water supply hose and drain hose are not frozen before use.
- Check the care labels and the product instructions when using detergent before washing.
ENGLISH
DRESSCODE 7200 / 8200 / 9200 / 10200 INVERTER
DRESSCODE 7200 / 8200 / 9200 / 10200 INVERTER STEEL
59