Hilti NURON SF 6-22 Manual De Instrucciones página 29

5.5 Inserting the accessory tool
1. Open the keyless chuck.
2. Insert the accessory tool into the chuck.
3. Tighten the keyless chuck.
4. Check that the accessory tool is held securely.
5.6 Fall arrest
WARNING
Risk of injury by falling tool and/or accessory!
▶ Use only the Hilti tool tether recommended for your product.
▶ Prior to each use, always check the attachment point of the tool tether for possible damage.
▶ Do not secure a tool tether to the belt hook. Do not use a belt hook to lift the product.
Comply with the national regulations for working at heights.
As drop arrester for this product, use only a combination of the Hilti retaining strap and the Hilti tool tether
#2261970.
▶ Secure the retaining strap to the installation openings for accessories. Check that it holds securely.
▶ Secure one carabiner of the tool tether to the retaining strap and secure the second carabiner to a
load-bearing structure. Check that both carabiners hold securely.
Comply with the operating instructions of the Hilti retaining strap and those of the Hilti tool tether.
6 Operation
CAUTION
Risk of injury if the accessory tool stalls !
▶ Check that the side handle is fitted correctly and tightened securely. Always hold the tool with both
hands on the grips provided.
▶ Wear eye protection to prevent splintering material from injuring your eyes.
Observe the safety instructions and warnings in this documentation and on the product.
6.1 Selecting the gear
▶ Select the gear.
6.2 Setting forward or reverse rotation
▶ Set the forward/reverse switch to forward or reverse rotation, as applicable.
6.3 Switching on
▶ Press the control switch.
▶ The product starts.
Speed can be controlled steplessly by varying how far the control switch is pressed in.
6.4 Screwdriving 6
▶ Set the torque and operating mode selector ring to the required torque.
6.5 Drilling 6
▶ Set the torque and operating mode selector ring to
*2275217*
3
4
5
2275217
.
English 23