Hilti NURON SF 6-22 Manual De Instrucciones página 31

▶ Prior to each use and before and after prolonged transport, check the product and the batteries for
damage.
Storage
WARNING
Accidental damage caused by defective or leaking batteries !
▶ Always store your products with the batteries removed!
▶ Store the product and the batteries in a cool and dry place. Comply with the temperature limits stated in
the technical data.
▶ Do not store batteries on the charger. Always remove the battery from the charger when the charging
operation has completed.
▶ Never leave batteries in direct sunlight, on sources of heat, or behind glass.
▶ Store the product and batteries where they cannot be accessed by children or unauthorized persons.
▶ Prior to each use and before and after prolonged storage, check the product and the batteries for
damage.
9 Troubleshooting
If a problem occurs, always observe the charge-status and fault indicator of the battery. See the section
headed Status indicators of the Li­ion battery.
If the trouble you are experiencing is not listed in this table or you are unable to remedy the problem by
yourself, please contact Hilti Service.
Trouble or fault
Product does not work.
The control switch cannot be
pressed, or is stuck.
Product or battery gets very
hot
LEDs of the battery show
nothing
SF 6H-22
Hammer-action drilling is not
possible.
10 Disposal
WARNING
Risk of injury due to incorrect disposal! Health hazards due to escaping gases or liquids.
▶ DO NOT send batteries through the mail!
▶ Cover the terminals with a non-conductive material (such as electrical tape) to prevent short circuiting.
▶ Dispose of your battery out of the reach of children.
▶ Dispose of the battery at your Hilti Store, or consult your local governmental garbage disposal or public
health and safety resources for disposal instructions.
Most of the materials from which Hilti products are manufactured can be recycled. The materials must be
correctly separated before they can be recycled. In many countries, your old tools, machines or appliances
can be returned to Hilti for recycling. Ask Hilti Service or your Hilti sales representative for further information.
▶ Do not dispose of power tools, electronic equipment or batteries as household waste!
*2275217*
Possible cause
The battery is not correctly in-
serted.
The forward/reverse switch is in
the middle position (transport posi-
tion).
Electrical fault
Battery defective
The operating mode is not set cor-
rectly at the selector ring.
2275217
Action to be taken
▶ Insert the battery. → page 22
▶ Set the forward/reverse switch
to forward or reverse rotation,
as applicable. → page 23
▶ Switch the product off immedi-
ately and remove the battery.
Allow it to cool down while
keeping it under observation.
Contact Hilti Service.
▶ Contact Hilti Service.
▶ Set the selector ring to the
"Hammer-action drilling" posi-
tion .
English 25