Publicidad
Idiomas disponibles
Idiomas disponibles
The air conditioner must be installed on a wall that communicates
with the outside
After determining the best place for installation as described above,
check for the absence of other structures or systems (beams, piers,
pipes, wires, etc.) at the points where the holes are to be drilled,
which would prevent drilling the holes required to install the unit.
Check again to make sure there are no obstacles to air circulation
through the holes to be drilled due to plants and their leaves, slats
or panelling, blinds, gratings or grids too dense, etc.).
2.4 - UNIT ASSEMBLY
The maximum length allowed for the pipes is 1 m, the pipes must
be internally smooth and no bends can be made.
It is necessary to use the grilles provided, or grilles which keep
the same features.
2.4.1 - Drilling the wall
Install the unit by drilling two holes (diameter of either 162 mm or 202 mm) in the wall
as indicated in the drilling template.
•
It is possible to install the unit UNICO R instead of a unit UNICO EDGE or UNI-
CO without modifying the already existing holes, exception made for the small
condensation drain hole.
In this case, in order not to penalize performances, remove the insulating material
possibly present in the air expulsion hole. The anchoring brackets need new
drilling too.
•
Drill the wall using the proper tools to facilitate your job and prevent excess
damage or disturbance to your client.
The best tools for drilling large holes in walls are special drills called core borers
with very high twisting torque and adjustable rotating speed depending on the
diameter of the hole to be drilled.
•
To prevent the creation of large amounts of dust and rubble due to drilling, the
core borer can be fitted with a vacuum system applied by means of suction cups
to the drilling zone.
EN - 14
Publicidad
