Changing The Brake Pads; How To Use Your Kickway L1 Scooter - Wayscral Kickway L1 Manual De Instrucciones

Check the alignment of the pads by turning the wheel. Your
•
scooter is ready to ride.
Disc: your scooter is fitted with a disc brake of 110 mm in
•
diameter.
A screw system on the brake lever allows you to adjust the cable
•
tension and so the braking force which will vary over time
depending on the wear of the brake pads.
Brake pads are standard, replace them when your pad no longer
•
has a friction component.
Remember that new brake pads must be broken in. They are broken in
by riding for a few minutes and alternating between sudden stops and
light braking.

2. Changing the brake pads

Remove the brake caliper from its placement and remove the worn pads
from the brake. Position the new pads in the caliper so that the braking
surfaces come into contact. Do not touch the braking surfaces. Insert the
pads one after the other into the brake caliper.
Then adjust the brakes as described in the previous paragraph.
C. How to use your Kickway L1 scooter
Step 1: check that the rubber cover is covering the charging
•
connector and that your product is not damaged.
Step 2: unfold the scooter as recommended in section "III.
•
Folding and unfolding the scooter" and press the red button
above the rubber cover for 1 second.
Step 3: Once the scooter is switched on, place one foot on the
•
foot rest and move forward by pushing the other foot forward on
the ground and by activating the accelerator.
60