Charging Procedure - Wayscral Kickway L1 Manual De Instrucciones

G. Charging procedure
Recharge the scooter's battery according to the following procedure:
The battery can be charged using a standard power outlet.
•
Insert the charger plug into the charging connector of the battery
•
by lifting the rubber cover over the charging connector on the rear
left side of the footrest.
Make sure that the charging connector is dry and plug the power
•
cable of the charger into a nearby power outlet.
When charging, the LED on the charger will be red to show that
•
it is working correctly. When it turns green, it means that the
battery is charged.
To finish charging, you must disconnect the power plug and then
•
the plug connected to the battery. Finally close the cap of the
battery socket.
Unplug the mains plug
•
IMPORTANT:
Charging for too long may shorten the life of the battery. Do not
•
leave your Kickway L1 scooter charging overnight.
Keep the charging environment clean and dry.
•
Do not charge the battery if the charging plug is wet.
•
Lift the rubber
flap.
70
Plug the
When charging is
power adapter
complete, replace
into the
the rubber flap.
charging port.