Drying; Assembly Of The Filling Chamber Cap - Vapormed Volcano MEDIC 2 Modo De Empleo

Push the lower Screen upwards out of
the Filling Chamber Housing.
Push the lower Screen out

9.4.4. Drying

All component parts of the Filling
Chamber must be completely dry be-
fore reassembly.
Put all component parts of the Filling
Chamber on a clean, dry, and absor-
bent pad and allow them to dry thor-
oughly. A hair dryer may be used for
faster drying. Do not dry in wet rooms
(e.g. not in the bathroom).
9. H Y G I E N E
9.4.5. Assembly of the Filling
Assemble the components in the re-
verse order:
Slide the cap cylinder into the cap
housing until it clicks, then pull the cap
ring from above over the cap cylinder
to the cap housing.
When using hemp flowers, push the
upper Screen from below into the cap
cylinder until it clicks into the desig-
nated notch.
When using dronabinol solution, the
Lower Screen
two Screens are not needed. Only the
Drip Pad is inserted instead of the
Filling Chamber
lower Screen.
Cylinder
Filling
Chamber
Housing
117
Chamber Cap
Cap Ring
Cap Housing
Touch Guard
Cap Cylinder
Upper Screen