Descargar Imprimir esta página

Canopy Assembly - Craftmade Prost PRT78 Guia De Instalacion

Publicidad

Idiomas disponibles

Idiomas disponibles

6. Wiring. (cont.)
[PLEASE NOTE: Wall and/or handheld remote
control must be used for fan to operate. If you do
not wish to use the wall control, please proceed to
Section 7 below to continue with fan installation.]
To install wall control, remove existing wall
switch. Wire one of the wall controls with wire
connectors provided as shown in diagram at right.
*Wrap each wire connector separately with
electrical tape as an extra safety measure. Gently
push wires and taped wire connectors into outlet
box.
Install one 12-volt battery (included) in wall
control.
IMPORTANT: Wall control will not function unless
battery is installed.
WARNING: Battery is to be inserted with the
correct polarity.
Attach wall control to outlet box and secure with
screws from original wall switch. Attach plate
(included) to wall control using 2 screws provided
with the wall control.

7. Canopy Assembly.

Locate 2 screws on underside of hanging bracket
and remove screw closest to the open end of the
hanging bracket. Partially loosen the other screw.
Lift canopy to hanging bracket. Place rounded part
of slotted hole in canopy over loosened screw in
hanging bracket and push up. Twist canopy to lock.
Re-insert screw that was removed and then tighten
both screws securely.
Slide canopy cover up to canopy, aligning rounded
part of slotted holes in canopy cover with
screwheads in bottom of canopy. Turn canopy
cover to the right (clockwise) until it stops.
outlet box
green/
green/
green/
bare
bare
bare
ground
ground
ground
black
black
(TO POWER supply)
black
(AC IN from
breaker box)
(wiring for wall control)
canopy
screw
page 9
wall
control
I
I
I
I
I
I
IV
II
V
VI
I
green
black (OUT to fan)
12V battery
hanging
bracket
screw
canopy cover
plate

Publicidad

loading

Este manual también es adecuado para:

Prost prt102Prost prt120