Descargar Imprimir esta página

Light Kit Assembly - Craftmade Prost PRT78 Guia De Instalacion

Publicidad

Idiomas disponibles

Idiomas disponibles

9. Light Kit Assembly.

Remove 1 screw from motor plate on underside of
motor housing and partially loosen the other 2
screws. Align slotted holes in fitter plate with
loosened screws in motor plate, allowing male plug
and molex connections from motor housing to
come through hole in middle of fitter plate. Twist
fitter plate to lock. Re-insert screw that was just
removed and securely tighten all 3 screws with a
Phillips screwdriver.
Remove 1 screw from from outer edge of fitter plate
and partially loosen the other 2 screws. Connect
male plug from motor housing to female plug from
light kit fitter plate, matching up the colors on the
male plug with the colors on the female plug for
correct fit. Be sure that plugs connect securely.
Align slotted holes in light kit fitter plate with
loosened screws in fitter plate, allowing molex
connections from motor housing to come through
hole in middle of light kit fitter plate. Twist light kit
fitter plate to lock. Re-insert screw that was just
removed and securely tighten all 3 screws with a
Phillips screwdriver.
Remove 1 screw from from underside of light kit
fitter plate and partially loosen the other 2 screws.
If you wish to use the light kit, connect WHITE wire
from LED light kit to WHITE wire from motor
housing. Connect BLACK wire from LED light kit to
BLUE (or BLACK) wire from motor housing. Be sure
that molex connections snap together completely.
Carefully arrange wiring within lit kit fitter plate.
Align slotted holes in LED light kit with loosened
screws in light kit fitter plate. Twist LED light kit to
lock. Re-insert screw that was previously removed
and tighten all 3 screws securely.
Align grooves on shade with nodules on inside of
LED light kit and push up gently on shade. Twist
shade to the RIGHT (clockwise) until shade locks
into place. Pull down VERY GENTLY on shade to
make sure that shade is secure.
If you do NOT wish to use the light kit,
on metal cover and align with nodules inside
light
kit. Gently push up on metal cover and turn to
the
RIGHT (clockwise)
until it no longer turns.
WARNING:
Do NOT connect the molex connections
for the LED light kit if you do NOT wish to use the
light.
WARNING: Metal cover will be HOT if light is left on.
connections
locate slots
LED
LED light kit
page 11
molex
connections
molex
grooves
motor housing
motor plate
fitter plate
motor housing
fitter plate
light kit fitter plate
molex
connections
light kit
fitter plate
LED light kit
grooves
shade
motor housing
light kit
fitter plate
nodules
metal cover

Publicidad

loading

Este manual también es adecuado para:

Prost prt102Prost prt120