Wireless Function - A&D Medical PREMIUM WIRELESS Manual De Instrucciones

USING THE MONITOR

Wireless Function

In the unlikely event that this monitor causes radio wave
interference to a different wireless station, change the
location where this monitor is used or stop use immediately.
Be sure to use in a location where visibility between the two
devices that you want to connect is good. The connection
distance is reduced by the structure of buildings or other
obstructions. In particular, connection may be impossible
when devices are used on either side of reinforced concrete.
Do not use the Bluetooth
of a wireless LAN or other wireless devices, near
devices that emit radio waves such as microwaves, or
in other locations where signal strength is weak. Doing
so may result in frequent loss of connection, very slow
communication speeds and errors.
Using close to an IEEE802.11g/b/n wireless LAN device
may cause mutual interference to occur, which may result
in reduced communication speeds or which may prevent
connection. In this case, switch off the power supply to
the device that is not being used, or use the monitor in a
different location.
If the monitor does not connect normally when used near
a wireless station or broadcast station, use the monitor in
a different location.
A&D cannot accept liability for any damages incurred due
to impaired operation or data loss, etc. that occur through
the use of this product.
This product is not guaranteed to connect to all Bluetooth
compatible devices.
connection in the range
®
®
E-13