Assembly - Jetboil FLASH Manual De Instrucciones

ASSEMBLY

• Perform Leak Checks outside, in a well-ventilated area.
• Operate at least 1m/3.3ft away from combustible materials and ignition sources.
• Before each use: Keep stove area clear and free from combustible
materials, gasoline, and other flammable vapors and liquids.
• Do not obstruct the flow of combustion and ventilation air to the stove.
• Do not use windscreen or outback oven; this can overheat the fuel canister,
resulting in explosion.
• Do not use an appliance which is leaking, damaged or which does not operate properly.
• Always change gas canisters in a well ventilated location away from any
sources of ignition, such as naked flames, pilot, electric heaters/equipment
and away from other people.
1. Remove packed contents from pot (Fig 1).
2. Perform LEAK CHECK PROCEDURE (See Page 4).
3. Unfold the bail (2.1) from the valve body (2.2).
4. Close the control valve (8.1) (turn clockwise).
5. Check for debris in the valve connection (1.1), and that the O-Ring is in place
and in good condition before connecting to the stove.
Do not use the appliance if it has damaged or worn seals, this may result in gas leakage.
In temperatures below freezing, O-Rings may not seal fully, resulting in a fuel leak.
6. To check that the gas canister is not empty, liquid fuel may be heard and/or felt
inside when the canister is shaken.
7. Connect fuel canister (3.1) to valve (3.2) by threading in the orientation shown in Fig
4. Hand tighten only, do not over-tighten or cross-thread. May damage
seals resulting in fuel leak.
8. Unfold stabilizer legs (2.3) and securely attach stabilizer to fuel canister (Fig 5).
9. Place assembled stove on a flat, level surface, at least 1m/3.3ft away from any
combustible materials or ignition sources.
10. If using Pot Support (sold separately): Unfold pot support legs (12.1), place it on top
of burner base and rotate to lock (12.2). Confirm that support is fully attached, seated and stable.
Never use alternate cookware without the Jetboil Pot Support. Failure to
use the Pot Support will result in a fire that may cause death or serious injury.
Never use cookware larger than 2L capacity or 9in. [23cm]
diameter when using a Pot Support.
WARNING
6