Operating Instructions - Jetboil FLASH Manual De Instrucciones

OPERATING INSTRUC
• Keep burner at arm's length, away from face, during ignition. Flame can
flare during ignition.
• Do not attempt to light with included pot or any other cookware on the
burner. Gas build-up can occur, resulting in increased flame eruption.
• Never expose stove to flammable vapors or liquids while lighting the burner.
It can cause an explosion or fire.
• Do not heat empty pot. Product will melt and potentially catch fire.
• Do not move, lift, or tilt stove with lit burner. Product damage or injury can
occur due to flaring.
• Do not fill above maximum fill line. This may cause boil-over, resulting in injury.
• If attempting to heat anything other than water, use care and stir frequently
to avoid boil over or scorching, which may result in product damage or injury.
• Always check that the burner is extinguished before disconnecting the fuel canister.
• Do not use for boiling oil or deep frying. Product damage or injury can occur
due to overheating.
Preparation:
1. Remove bottom cover (7.1) from bottom of the Jetboil pot (7.2). 2. Remove Pot
Support Warning Tag and Pack Bag (if included). 3. Add contents to the pot, cover
with lid, but do not put the pot on the stove yet. Now you are ready to light the burner.
4. Test igniter by depressing igniter button (8.2) until click is heard. If it does not
spark, refer to Maintenance and Troubleshooting sections.
Performance may be suboptimal if used in extreme conditions
(cold, hot, wind, altitude).
Do not use stove to warm fuel canister. Can result in explosion.
Lighting the Burner:
Ensure burner base is free of any pot prior to lighting. Gas build-up can
occur, resulting in increased flame eruption.
1. Open control valve (8.1) counterclockwise until fully opened and gas flow can be heard.
2. To light, depress Igniter Button (8.2) until click is heard. Repeat as necessary
until ignition (Fig 9). 3. If ignition does not occur within 5 seconds, close control
valves and wait 5 minutes before repeating the procedure.
Usage:
1. If necessary, rotate control valve (8.1) clockwise to decrease flame setting.
2. Once the burner is lit, carefully place the pot with its contents on the burner
base (Fig 10); turn as shown in Fig 11 to lock into place. 3. Heat indicator: As
the pot heats, the heat indicator (11.1) will turn from Black to Orange. If
7
the heat indicator is Orange, the pot and its contents are above 149°F (65°C).
WARNING