Operation Of The Appliance - Grundig GDSP2470BSCH Manual Del Usuario

3

Operation of the appliance

3.1 Controlling the Appliance
KEY
1 : Auto mode button
HobToHood and Auto
Mode functions cannot be
used at the same time.
2 : 1. Stage button
3 : 2. Stage button
4 : 3. Stage button
5 : Boost function
6 : Carbon filter warning
10 / EN
FUNCTION
It is used to make the choice between automatic and manual operation. When you
switch to automatic mode by pressing this button, the auto key lights on 1-2-3 re-
volution LEDs respectively by 100% and finally moves to the 1st revolution, where
it operates as 1 time light off and 1 time light on for 30 seconds. This duration
is sufficient for the sensor to activate. The sensor is used to measure air quality.
In automatic mode, if an increase in the value in the sensor is detected and the
engine is closed, the engine is run at the 2nd speed and the speed is automatically
changed. Auto key and speed key are indicated by lightening 100% while the
engine is running. When the auto key is pressed or the speed is changed while
auto mode is active, the changed speed indicator lights up 100% and the engine
switches to that speed and the auto key indicator lights up 50% and the auto is
cancelled. If nothing happens to allow the engine to start again within 15 minutes
while the engine is off, the automatic position is exited. If the hood is switched off
with the On/Off key in the automatic position, the auto is cancelled.
Auto Mod Sensitivity Setting: There are 3 precision settings as Lowest (1) to
highest (3). The factory default is (2), medium level. If you want to change the
sensitivity, press Auto/Mode key for 3 seconds and you enter into sensitivity set-
ting. The current stage is flashed on the speed LEDs. The sensitivity level can be
changed by pressing the Auto/Mode button. The last level shown is continuously
valid. The levels increase relatively easy when high precision is selected; when low
precision is selected it is increased relatively hard.
Operates the appliance on 1st speed. It is used to change the engine speeds.
When the hood is ON, the brightness of these keys is 50%. The illumination of the
selected speed will be 100%.
Operates the appliance on 2nd speed. It is used to change the engine speeds.
When the hood is ON, the brightness of these keys is 50%. The illumination of the
selected speed will be 100%.
Operates the appliance on 3rd speed. It is used to change the engine speeds.
When the hood is ON, the brightness of these keys is 50%. The illumination of the
selected speed will be 100%.
In almost 10 minutes after the activation of this function, it goes to the lower en-
gine speed. When the Boost function is active, the boost key lights up by flashing
100%. Timer function cannot be activated when the engine is at the top speed.
When timer is taken to the top level while it is active, the timer is cancelled. It is
used to change the engine speeds. When the hood is ON, the brightness of these
keys is 50%. The illumination of the selected speed will be 100%.
The electronic unit records the operating time of the engine. When the operation
of the engine reaches to the specified time, you will be warned that the filter must
be replaced by lightening up the relevant LED. If you press to 1st speed button
about 5 seconds when this filter warning LED is on, the filter time resets and the
180-hour process restarts.
Cooker Hood / User Manual