Publicidad
Idiomas disponibles
Idiomas disponibles
I N S TA L L AT I O N
2.
Applying trim to flanged downlight
If your ceiling's substrate is thicker than 0.625–1 in (15.875–25.4 mm), adjust the springs on either side
of your trim:
a.
Using a #1 screwdriver, loosen the screw holding the spring in place.
b.
Raise the spring as high (as far from the bottom of the trim) as it will go.
c.
Re-tighten the screw (see fig. 12).
8
D
C
B
fig. 12
NOTES:
1) CIRCLED DIMENSIONS ARE CRITICAL AND SUBJECT TO INSPECTION
2) MATERIAL:
3) FINISH:
A
4) COLOR:
5) ANY DEVIATIONS OR SUBSTITUTIONS MUST FIRST BE APPROVED BY A KETRA ENGINEER
6) PARTS TO BE CLEAN AND FREE FROM MACHINE OIL, REMOVE ALL BURRS AND BREAK SHARP EDGES
PROPRIETARY AND CONFIDENTIAL
THE INFORMATION CONTAINED IN THIS
DRAWING IS THE SOLE PROPERTY OF
KETRA, INC. ANY REPRODUCTION
IN PART OR AS A WHOLE WITHOUT THE
3815 S. CAPITAL OF TEXAS HIGHWAY SUITE 100
WRITTEN PERMISSION OF KETRA, INC.
AUSTIN, TEXAS 78704 (512) 347-1100
IS PROHIBITED.
3.
Compress the springs and push into the downlight aperture until the trim is flush to the ceiling.
8
Ensure that the springs are properly compressed and are going into the collar, not around the collar
(see fig. 13).
4.
Snap the trim into the collar.
Trim Installation and Removal
16 | D3 INSTALLATION GUIDE
7
6
5
DATE
DRAWN BY
UNLESS OTHERWISE SPECIFIED:
STEVE COAKLEY
2/21/2016
DIMENSIONS ARE IN MILLIMETERS
Vendor
Vendor PN
TOLERANCES:
DECIMAL
.X
+/- 0.5MM
ANGLE
VERSION
PHASE
.XX
+/- 0.25MM
+/- 1°
DEVELOPMENT
.XXX +/- 0.125MM
7
6
5
fig. 13
4
3
2
REVISIONS
REV.
ECO
DESCRIPTION
01
INITIAL RELEASE
DESCRIPTION
SIZE
TRIM, SQUARE, BEVEL
B
THIRD ANGLE
PROJECTION
INTERPRET GEOMETRIC
TOLERANCING PER:
ASME Y14.5 - 2009
WEIGHT
79.14 g
4
3
2
© 2019-2022 Ketra, Inc. All rights reserved.
1
DATE
APPROVED
D
C
B
A
DWG. NO.
REV
860-000067-XX
01
DO NOT SCALE DRAWING
1
1
SHEET
OF
SCALE:
1:1
1
Ketra Format REV-08
P/N 3662708 Rev A
Publicidad
Solución de problemas
