Additional Operations - Ketra D3 Serie Guia De Instalacion

Additional Operations

1. Re-aiming the optic
a. Remove the trim by pulling the trim directly down from the housing.
b. Unlock the emitter chassis: reach into the D3's housing and unlock tilt lock and rotation lock levers
(both colored red) (see fig. 14).
c. Use the degree indicators to determine degree of rotation (square trim only) and tilt (see fig. 15).
Rotation Lock and Release
Locked Unlocked
fig. 14
2. Adjusting optic depth
a. Remove the trim by pulling the trim directly down from the housing.
b. To set optic at the deep regress position push optic directly up.
Light engine will magnetically lock into place (see fig. 16).
c. To set optic at the low regress position pull optic directly down.
Light engine will magnetically lock into place (see fig. 17).
Emitter Regress Depth Adjust
To Raise: Push
fig. 16
P/N 3662708 Rev A
© 2019-2022 Ketra, Inc. All rights reserved.
Tilt and Rotation Angle Indication
Unlocked
Tilt
To Lower: Pull
fig. 17
Tilt and Rotation Angle Indication
Tilt
fig. 15
Rotation (Square Trim Only) Rotation (Square Trim Only)
D3 INSTALLATION GUIDE | 17