eNGLISH
Information and safety instructions for the responsible body
DANGeR!
WARNING!
WARNING!
WARNING!
WARNING!
WARNING!
44
ORBITALUM TOOLS GmbH D-78224 Singen www.orbitalum.com
Defective safety components due to soiling, breakage and wear!
The failure of safety components can cause physical injury.
X Do not misuse the cable, e.g. such as using it to suspend or carry the machine.
X Replace defective safety components immediately and check them daily to ensure proper operation.
X Have an expert replace defective power cables immediately.
X Clean and perform maintenance on the machine after each use.
X Keep cables away from heat, oil, sharp edges and moving equipment parts.
X Inspect the machine daily for visible signs of damage or defects, and have them repaired
by a specialist if necessary.
Flying parts/breaking tool!
Diverse physical injuries and material damage.
X Do not process the tube while it is loose in the vice.
X Never use a damaged or deformed saw blade and/or bevel cutter.
X In the event of tool breakage with a new tool, do not enter the old cut because the tool
can break again.
X Clamp the tube to be cut into the vice.
X Immediately replace worn-out tools.
X Ensure that the cutting tools are correctly fitted.
X Tube dimension must be set correctly. During cutting, the saw blade must saw through
the entire tube wall.
X Avoid breaking tool through low (adequate) feed force, correct dimension (chap. 8.6, p. 62)
and speed (chap. 9.2, p. 66) settings.
X Hold on to the motor unit tightly by the handle, and guide it with low (adequate) feed
force during the machining process.
Falling objects or tilting and bending tubes!
Irreversible crushing.
X Wear safety shoes (in accordance with EN ISO 20345, at least S1).
X Place sufficient supports under the tube.
X Transport the machine as shown in chap. 7.2, p. 55.
Danger caused by vibration and unergonomic, monotonous work!
Discomfort, tiredness and disruptions to the locomotor system.
Limited ability to react, and cramps.
X Do relaxation exercises.
X Ensure activity is varied.
X Assume an upright, fatigue-free and comfortable body position during operation.
Pressing the ON-OFF switch unintentionally!
Diverse physical injuries and material damage.
X At the end of each working cycle, before transportation, changing tools, cleaning and
performing any maintenance, adjustment or repair work, switch off the machine, wait
until the machine/tool stops running and pull the mains plug.
Dangerous laser radiation!
The eye retina or eye vision can be impaired.
X Do not look at the laser beam or view it using optical instruments.
X Do not point the laser beam at other people.
X Do not misuse the line laser and do not remove from the tube saw.
X Ensure that the line laser is switched off during mounting/dismantling.
GFX 3.0, GFX 6.6
[REV. 20200320] OC_GFX_BA_790144761_00__INH-02_EN