Shutting Down (Even In An Emergency) - Orbitalum GFX 3.0 Traducción Del Manual De Instrucciones Original

GFX 3.0, GFX 6.6
WARNING!
ATTeNTION!
ATTeNTION!
9.1

Shutting down (even in an emergency)

IMPORTANT!
WARNING!
To be able to stop the machine (also in case of emergency), perform the corresponding
steps and immediately remove from the danger area, until the machine comes to a stop:
X Activate by switching the ON/OFF toggle switch (1).
If the ON/OFF toggle switch (1) fails to work (1):
X Remove the plug from the socket or vacate the danger zone as quickly as possible and then
unplug the power plug.
[REV. 20200320] OC_GFX_BA_790144761_00__INH-02_EN
Flying, hot and sharp-edged chips, tube surfaces, cutting edges and tools!
Danger of injury to eyes and hands.
X Do not reach into the rotating tool during working.
X Never work without the saw chip guard mounted.
X Wear recommended protective clothing.
X Only remove chips with tight-fitting safety gloves (in accordance with DIN EN 388 and EN
407, see chap. 2.4, p. 42).
X Make sure the chips guard is working.
Restarting the machine following blockage!
Diverse physical injuries and material damage.
X In the event of a blockage, always disconnect the machine from the power supply before
clearing it.
X If necessary, remove any tensioned parts before restarting the machine.
Vapors when working with lubricants!
Damage to lungs, skin and the environment.
X Only use original lubricant recommended by Orbitalum Tools.
Warning messages are used in these instructions to warn you of possible risk of death, injury
or damage to property. Always read and observe these warning messages! To ensure safe
setting up and mounting please read all the warning messages in chap. 2, p. 40 and chap. 9,
p. 64 attentively.
eMeRGeNcY STOP function not available by unplugging the power plug!
Diverse physical injuries and material damage.
X Do not use angled power plugs.
X Do not use click-in socket outlets and click-in power plugs (blue CEE power plugs) for
power connection, otherwise the EMERGENCY STOP does not function. The user must
check whether the power plug can be pulled out of the outlet by the cable.
X Only use original Orbitalum Tools parts.
X Ensure free access to the power plug.
X Leave the danger zone until the machine stops moving.
Operation
Orbitalum Tools GmbH D-78224 Singen www.orbitalum.com
eNGLISH
1
65