Mounting On The Workbench With Quick-Mounting Plate Without Screw Clamps; Mounting The Line Laser - Orbitalum GFX 3.0 Traducción Del Manual De Instrucciones Original

eNGLISH
Set-up and assembly
8.1.3

Mounting on the workbench with quick-mounting plate without screw clamps

Only possible with the GFX 6.6.
NOTe!
1. Mark and punch the bolt holes on the workbench. Use the quick-mounting plate as a template.
2. Drill Ø 13 mm (0.5") holes.
3. Fasten the quick-mounting plate with screws.
4. Guide the GFX 6.6 sideways onto the fitted quick-mounting plate.
5. Tighten the hexagon screw (2) so that it lies firmly on the retainer at the vice of the saw (3).
1
8.2

Mounting the line laser

IMPORTANT!
NOTe!
WARNING!
1. Place the line laser on the intended location surface (1) on the housing.
2. Tighten the line laser lightly with 2 hexagon socket head screws (2) so that it can still be aligned.
3. Switch on the line laser and align it so that the line laser beam lies flush with the saw blade (3).
4. Tighten the 2 hexagon socket head screws (2) and switch the line laser off again.
58
ORBITALUM TOOLS GmbH D-78224 Singen www.orbitalum.com
At the GFX 6.6 the quick-mounting plate has to be mounted directly on the left-hand workbench
edge, so that the vice handle (1) at the side of the GFX 6.6 can be turned in its full radius with
sufficient distance to the workbench edge.
2
Warning messages are used in these instructions to warn you of possible risk of death, injury
or damage to property. Always read and observe these warning messages! To ensure safe
setting up and mounting please read all the warning messages in chap. 2, p. 40 and chap.
8, p. 56 attentively.
The line laser is supplied separately with the machine and has to be mounted on the GFX
before commissioning.
Dangerous laser radiation!
The eye retina or eye vision can be impaired.
X Ensure that the line laser is switched off during mounting/dismantling.
GFX 3.0, GFX 6.6
3
2
[REV. 20200320] OC_GFX_BA_790144761_00__INH-02_EN