Setting The Tube Dimension Without A Scale; Setting The Tube Dimension When Using An Additional Cutter - Orbitalum GFX 3.0 Traducción Del Manual De Instrucciones Original

GFX 3.0, GFX 6.6
8.6.2

Setting the tube dimension without a scale

1. Place the tube in the vice.
2. Slide the tube forwards until it is close to the saw
blade.
3. Clamp the tube in the vice.
4. Loosen the star knob (1) and set to the greatest
possible dimension. Do not tighten.
5. Raise the motor of the tube cutter in the direction of
the arrow as if to saw until the teeth of the saw blade
protrude approx. 1.5 mm/0.059" (approx. height of
saw blade teeth) into the center of the tube.
6. Tighten the star knob (1).
7. Turn the tube saw back to the home position.
8.6.3

Setting the tube dimension when using an additional cutter

Steel tubes with a wall thickness of 7 mm (0.276") can be
simultaneously cut and beveled.
1. Place the tube in the vice.
2. Slide the tube forwards until it is close to the additional
cutter.
3. Clamp the tube in the vice.
4. Loosen the star knob (1) and set to the greatest
possible dimension. Do not tighten.
5. Pull the motor of the tube saw upward in the arrow
direction as for sawing until the bevel cutter covers
the tube wall.
6. Tighten the star knob (1).
7. Turn the tube saw back to the home position. Perform
a test bevel and check the bevel (chap. 9, p. 64).
Bevel OK
[REV. 20200320] OC_GFX_BA_790144761_00__INH-02_EN
1
1
Move the star knob (1)
slightly to the right
Orbitalum Tools GmbH D-78224 Singen www.orbitalum.com
Set-up and assembly
Move the star knob (1)
slightly to the left
eNGLISH
63