Publicidad
Idiomas disponibles
Idiomas disponibles
Gather the required tools and parts before starting the
installation. Read and follow the instructions provided with
any tools listed here.
Tools/Materials required
•
Drill
•
1
⁄
" (3 cm) drill bit
1
4
⁄
" (0.5 mm) drill bit
•
3
1 6
•
Pencil
•
Wire stripper or utility knife
•
Tape measure or ruler
•
Pliers
•
Caulking gun and weatherproof caulking compound
•
Vent clamps
•
Jigsaw or keyhole saw
•
Metal snips
•
Screwdrivers
•
Phillips
•
Flat-blade
Supplied Part
Strain relief connector (13.5)
4.2x8 mm screws
6-wire blower connector
4x1.8mm flat washers
Spring tab
6.3 x 60 mm screws
Support bracket
10x50 mm wall anchors
Tools and parts
Parts not supplied
• 6 AWG wires, one each of the following colors: black, white,
red, blue, gray, and green/yellow (ground)
NOTE: The length of the conduit and AWG wires is
determined by the distance between the in-line blower
motor and range hood terminal boxes.
• 11 - UL listed wire connectors.
Parts supplied
Removing parts from the packages. Check that all parts are
included.
•
Shell for blower motor assembly
•
Hardware bag with:
Pieces
2
33
1
4
1
7
1
7
Supplied Part
6.5 X 3.5 mm screws
Ø 12 mm strain relief
6x13.5 mm
Torx adapter
Clip nuts
Strap 2.5x 95 mm
6 x 16 mm screws
Pieces
10
1
2
(T10)1
(T20)1
4
3
4
5
Publicidad
