Faber LYBRA PLUS Manual De Uso página 6

If the above-mentioned steps have not
solved the problem, contact technical
support.
4. CONTROLS
Key Function
L Short press: the lights alternate between high intensity, medium intensity (if
present) and off.
If there is an induction cooktop coupled with the hood and the hood is off, as
soon as the induction cooktop is turned on, the hood lights automatically turn on
at the maximum intensity.
K-Link coupling
Before starting the procedure follow the specific instructions of the manuals of the
devices to be coupled.
Long press when all loads are off (Motor+Light):
starts the pairing procedure between the hood and compatible K-Link devices (in-
duction cooktop or remote control). Up to 3 induction cooktops can be paired and
only one remote control. See the manual of the devices for details of the opera-
tions that need to be performed on these.
The coupling procedure takes 2 minutes. If no devices are recognised within this
time check that you have previously activated the procedure for the devices to be
coupled. The maximum number of linkable devices may have been reached.
T1 Hood open:
Turns the motor on/off at the first speed.
By pressing and holding the key for about 3 seconds, the motor is switched off
and the hood upward movement is activated.
Hood closed:
When pressed once, the hood moves down; when pressed again, the hood
stops. This condition should be considered as hood open even if it is not com-
pletely open; all functions are enabled.
When the movement has ended, the motor starts at speed 2.
K-Link uncoupling
Long press when all loads are off (Motor+Light):
starts the procedure for the cancellation of all compatible K-Link devices previ-
ously paired with the K-Link Coupling function.
Recommended device coupling sequence:
1 - K-Link Mode (See remote control manual)
2 - K-Link Coupling (See hood manual)
3 - Remote Control-Hood Coupling (See remote control manual)
4 - K-Link Coupling (See hood manual)
5 - Cooktop-Hood Coupling (See induction cooktop manual)
6
LED
T1 Led
flashes:
coupling in progress.
When the procedure has
been successfully completed,
the T1 Led stays on for 2
seconds.
On/Off
-
-
When the procedure has
been successfully completed,
the T1 Led flashes 5 times.