Regulator Replacement - Planika KL21 Square Manual De Instalacion Y Uso

3.5.2. Regulator replacement

1.
You always need to use a pressure regulator between the gas bottle and the device. Replace the pressure
regulator every 5 years. Allowed pressures: 30 mbar, 37 mbar (recommended), 50 mbar. Use only the regulators
that comply with the EN16129 European Norm.
2.
Turn off The Square -– the „OFF" position. The main burner need to be turned off.
3.
Disconnect the regulator from the gas bottle (description above).
4.
Cut off attached pressure
reducer or go to step 4.1. if
you have pressure reducer
with clamp connection.
5.
Replace the regulator to
new one with clamp
connection by attaching
new linkage on the stub of
regulator.
6.
Move the clamp into the
stub
7.
Tighten the clamp with
screwdriver (philips) or a
flat wrench.
WARNING! In the event of
visible damage on the
clamp, replace it for a new
one.
4.1. Loosen the metal clamp
with the use of a
screwdriver (philips) or a
flat wrench.
4.2. Move the clamp away
from the stub of gas
regulator and go to step 5
Twist-on connection
Twist-on connection
10
Quick-release
Quick-release