Publicidad
Idiomas disponibles
Idiomas disponibles
Right – / Left rotation
To achieve an optimally tuned to the corresponding material mixing effect,
the agitator is equipped with a switch for changing the direction of
This is located on the front of the machine frame above the handle.
Switch only at a standstill!
Right rotation:
Left rotation:
Speed control
The EZR 24 R R/L is equipped with an adjusting wheel in order to preselect
the required speed. The adjusting wheel is on the top side of the switch
handle (A – minimum, G – maximum).
automatically realises the soft start of the machine. Please pay attention
that in case of immediate switching OFF and ON again there is a switch-on
delay, because the motor first has to come to rest before it can restart.
Furthermore, please pay attention that a permanent use with reduced
speed can cause an overload because the motor then gets less cooling air
and therefore the machine will be overheated much faster.
The integrated temperature control protects the machine from thermal
overload. In such a case it switches off the motor. After a certain period of
cooling time the tool can be switched ON again.
Mounting of Special Stirring Rods
In order to work properly with the tool, it is important to mount the special
stirring rods in a specific position. For this purpose, turn the work spindles
so that the marks L and R show to the front. Then push the two enclosed
round rings on the end of the spindles. After that insert the stirring rods in a
way that the same marks are placed one below the other (picture 1).
For fixing the stirring rods in the work spindles push the enclosed metal pins
through the bore holes of spindle and stirring rod (picture 2).
The mixing paddles are working into the material and
convey this to the top. Use the clockwise rotation for
tough material (eg screed, concrete, plaster ...)
In reverse, the material is pushed by the stirring rods
downwards. Thus, a low injection mixing of materials
with a low viscosity is allowed (for example, paints,
encapsulants ...).
14
The integrated electronics
rotation.
Publicidad
