Publicidad
Idiomas disponibles
Idiomas disponibles
Hella Gutmann
1. Attach one wheel clamp module 1st GEN / wheel clamp module SE / wheel clamp module WA each on the left
and right rear wheel (see operating instructions of the CSC-Tool).
2. Attach the wheel clamp module Control to the front left wheel.
NOTICE
Pay attention that the level gauge bubble of the wheel clamp module Control is centered.
CAUTION!
Laser radiation
Damage to/destruction of the retina
Never look directly into the laser beam.
3. Switch on the laser beam of the wheel clamp module 1st GEN / wheel clamp module SE / wheel clamp module
WA (see operating instructions of the CSC-Tool).
4. Align the laser module by turning the mounting bolt on the scale of the wheel clamp module Control.
The laser beam is indicated on the scale of the wheel clamp module Control.
NOTICE
Do not turn the steering wheel of the parked vehicle.
5. Loosen the set screw of the wheel clamp module Control scale.
Now you can shift the scale horizontally.
6. Shift the scale until the laser point is indicated on the center line of the scale.
Wheel clamp module 1st GEN (dot laser):
Radaufnehmer Control
Working with the Wheel Clamp Module Control | 3.
23
Publicidad
