Descargar Imprimir esta página

Publicidad

Idiomas disponibles

Idiomas disponibles

CONNECTIONS
3.5mm jack steering wheel control retention:
The 3.5mm jack is to be used to retain audio controls on the steering wheel.
For the radios listed below, connect the female 3.5mm connector with stripped leads, to the male
3.5mm SWC jack from the wiring harness included with the kit. Any remaining wires tape off
and disregard:
Eclipse: Connect the steering wheel control wire, normally Brown, to the Brown/White wire
of the connector. Then connect the remaining steering wheel control wire, normally Brown/
White, to the Brown wire of the connector .
Metra OE: Connect the steering wheel control Key 1 wire (Gray) to the Brown wire.
Kenwood or select JVC with a steering wheel control wire: Connect the Blue/Yellow wire to
the Brown wire.
Note: If your Kenwood radio auto detects as a JVC, manually set the radio type to Kenwood.
See the instructions under changing radio type.
XITE: Connect the steering wheel control SWC-2 wire from the radio to the Brown wire.
Parrot Asteroid Smart or Tablet: Connect the 3.5mm jack into the AX-SWC-PARROT (sold
separately), and then connect the 4-pin connector from the AX-SWC-PARROT into the radio.
Note: The radio must be updated to rev. 2.1.4 or higher software.
Universal "2 or 3 wire" radio: Connect the steering wheel control wire, referred to as Key-A
or SWC-1, to the Brown wire of the connector. Then connect the remaining steering wheel
control wire, referred to as Key-B or SWC-2, to the Brown/White wire of the connector. If the
radio comes with a third wire for ground, disregard this wire
been programmed to the vehicle, refer to the manual provided with the radio for assigning
the SWC buttons. Contact the radio manufacturer for more information .
For all other radios: Connect the 3.5mm jack from the wiring harness included with the kit into
the jack on the aftermarket radio designated for an external steering wheel control interface.
Please refer to the aftermarket radios manual if in doubt as to where the 3.5mm jack goes to.
10
(CONT.)
. Note: After the interface has

INSTALLATION

With the key in the off position:
1. Connect the wiring harness included with the kit to the climate-display/hazard-switch
assembly, and then to the wiring harness in the vehicle.
2. Locate the factory antenna connector in the dash and complete all necessary connections
to the radio. Use the antenna adapter provided to adapt the factory antenna connector to
the aftermarket radio.
3. Connect the wiring harness included with the kit to the ASWC-1.
Attention! If retaining steering wheel controls, ensure that the SWC jack/wire is connected to the
radio before proceeding. If this step is skipped, the ASWC-1 will need to be reset for the steering
wheel controls to function.
|
386.257.1187
MetraOnline.com

Publicidad

loading