Error Messages - Mx Onda MX-PI2633FLEX Manual De Usuario E Instalacion

The hob produces a
humming noise
when used at a high
power level.
Fans noise coming
from the induction
hob.
The containers do
not heat up and
the display shows

ERROR MESSAGES

If an abnormality arises, the induction hob will enter the protection state
automatically and display the corresponding error codes:
Message
Protection against under voltage (<85
E 1 / E 2
V) or over voltage (> 285 V)
Induction coil temperature sensor
E 3
fault.
E 4
IGBT temperature sensor failure
High temperature (> 280 ºC) of the
E 5
induction coil temperature sensor.
E 6
High temperature at IGBT sensor
E r
Internal fault of the control circuits.
E E
There is excess liquid on the buttons
on the control panel
This is caused by
induction cooking
technology.
The fans that cools the
induction hob
turned on.
Prevent the hob from
overheating, the fans
can continue to work
after turning off
induction hob.
The cookware is not
suitable for induction,
the base of the cooker
is too small or it is not
centered on the
cooking zone.
Description
This is normal, the noise should be reduced or
disappear completely when the power is
decreased.
has
This is normal and is not a malfunction. Do not
turn off the power to the induction hob while
the fan is running.
the
Use cookware suitable for induction, with a
base large enough to be detected and center it
in the cooking zone
If the voltage at the mains outlet is lower or
higher than specified, consult a qualified
electrician.
Contact the closest MX ONDA Official
Technical Service.
Contact the closest MX ONDA Official
Technical Service.
Turn off the induction hob and wait for it to
cool down.
Check that the ventilation is correct and the
fans are not obstructed.
Contact the closest MX ONDA Official
Technical Service.
Clean and dry the control panel
18
Solution