Publicidad
Idiomas disponibles
Idiomas disponibles
Spills from
sugary foods
Dirt and spill stains
on the control panel
PROBLEM SOLVING
Problem
The induction hob
does not turn on
Touch buttons
do not work
Touch buttons are
not working properly
The surface of the
plate is scratched
Some
containers
make
noises
clicks
Remove them immediately using
a scraper suitable for induction
hobs, but be careful with hot
surfaces in the cooking zone:
1. Disconnect the power from the
board using the switch or
differential enabled for this.
2. Hold the scraper at a 30 °
angle and scrape dirt to a cool
area of the plate.
3. Wipe up dirt or spills with a
kitchen towel or paper towel.
1. Disconnect the power from the
board using the switch or
differential enabled for this.
2. Clean the control panel area
with a clean, damp sponge or
cloth.
3. Completely dry the control
panel area
4. Reconnect
power.
Possible causes
No mains power
The control panel is
locked
There may be a small
film of water or liquid
on the buttons or you
may be using the tip of
your
finger
touching the buttons.
Cookware can have
edges or edges that
will
deteriorate
hob. The utensils or
cleaning
products
used are not suitable.
Some containers have
or
a sandwich base
the
board
to
Make sure that the induction hob is connected
to the mains socket and that the switch or
circuit breaker is in the on position. Check if
you have light in the rest of your house. If you
have checked everything and the problem
persists, call a technician.
Unlock the control panel, see the
corresponding section.
Make sure the control panel area is clean and
dry. Use the pad of your finger when touching
the controls.
when
Use cookware with a flat, smooth bottom.
the
See the section "The induction cooker" and the
section cleaning the induction hob.
This is normal and is due to the type of base of
the container, this is normal and does not
indicate an anomaly or failure.
17
Remove stains from melting and
sugary foods or spills as soon as
possible. If allowed to cool on the
glass, it can be difficult to clean or
even permanently damage the
surface of the hob.
Cut Hazard - When the safety
cover is retracted, the blade on a
scraper becomes sharp. Use it with
great care and always store safely
and out of the reach of children.
Liquid spillage in the area of the
control
panel
may
induction hob to malfunction, the
touch
buttons
may
properly.
Be sure to thoroughly clean and
dry the control panel area before
reconnecting the board to power.
What to do?
cause
the
not
work
Publicidad
