Publicidad
en
Swing the vacuum cleaner forwards
until the Electrobrush connector aud-
ibly clicks into place.
Plug the supplied charging cable into
the charging socket on the bottom of
the battery.
Plug the charger into a power socket.
The charging process will start.
You can read more about this in "Bat-
tery charging state indicator (while
charging)".
Charging the battery (with wall
mounting) (Fig. 12)
You can store the vacuum cleaner in the
included wall bracket and charge the
battery at the same time.
Before charging the battery for the first
time, you must read the information in
"Installation and connection" – "Gen-
eral battery information".
You will need a suitable location near
a free power socket for mounting the
appliance on the wall.
You can screw or stick the included wall
bracket to the wall.
Screwing the wall bracket to the wall
(Fig. 13 + 14)
The included screw bag contains 2
plugs and 2 T20 TORX screws.
You will also need a battery-operated
screwdriver or a drill (with a drilling dia-
meter of 6 mm).
Select a distance of 104 cm between
the bottom edge of the wall bracket and
the floor (Fig. 13).
78
Be careful not to damage any cables
laid in the wall.
Attach the wall bracket to the wall
(Fig. 14).
Sticking the wall bracket to the
wall (Fig. 13 + 15)
The bag of accessories included with
the product contains an adhesive strip.
Select a distance of 104 cm between
the bottom edge of the wall bracket and
the floor (Fig. 13).
Clean the surface of the wall with a
soft, dust-free cloth.
Remove one of the two protective
films from the adhesive strip.
With the tab at the bottom, carefully
stick the adhesive strip to the back of
the wall bracket.
Press down hard and evenly on the
adhesive strip for at least 5 seconds.
Pull the second protective film up and
off the adhesive strip and stick the
wall bracket to the wall (Fig. 15).
Press down hard and evenly on the
wall bracket for at least 5 seconds.
To remove the wall bracket from the
wall, pull the black tab on the adhes-
ive strip down slowly parallel to the
wall.
Charging the battery in the wall
bracket (Fig. 16 + 17)
Slide the Comfort handle of the fully
assembled vacuum cleaner into the
wall bracket (Fig. 16).
Publicidad
