Publicidad
Plug the charging plug of the sup-
plied charging cable into the charging
socket on the bottom of the battery.
Plug the charger into the power
socket.
The charging process will start.
When you want to remove the vacuum
cleaner, you can store the charging plug
in the cable holder on the wall bracket.
Pull the charging plug out of the char-
ging socket on the battery.
Plug the charging plug into the cable
holder on the wall bracket (Fig. 17).
Battery charging state indicator
(while charging) (Fig. 18)
The battery charging state is displayed
on the PowerUnit.
Charging capacity
Approx. 0–34 %
Approx. 35–69 %
Approx. 70–90 %
Approx. 91–99 %
100 %
Once the battery is fully charged, the
battery charging state indicator
switches off to conserve energy.
Display
Bottom light
flashes slowly
Bottom light is
lit up; middle
light flashes
slowly
Bottom and
middle lights are
lit up; top light
flashes slowly
Bottom, middle
and top lights
are lit up
Switches off
If the battery has not been used for a
long time and has run down, it will go
into safe mode. As a result, the battery
charging state indicator will only re-
spond after approximately 30–60
minutes when charging in the
PowerUnit.
Battery charging state indicator
(while in use) (Fig. 18)
The battery charging state is displayed
on the PowerUnit.
Charging capacity
Approx. 100–70 %
Approx. 69–35 %
Approx. 34–15 %
Approx. 14–0 %
We recommend allowing the battery to
run down completely before recharging
it. In this way, you will benefit from the
battery's full capacity.
en
Display
Top, middle and
bottom lights
are lit up
Middle and bot-
tom lights are lit
up
Bottom light is
lit up
Bottom light
flashes slowly
79
Publicidad
