Routine Maintenance - Roborock Q7 Manual Del Usuario

Cleaning Mode Switch
• 4-Level Suction Power
Robot Information
• Cleaning History
• Battery Level
• Care & Maintenance
More Features
• Firmware Upgrade
• Volume Adjustment
• DND Mode
• Voice Assistance Support
Note: Features and details of the app may vary slightly due to
the continuous app development and updates.

Routine Maintenance

C
Main Brush
C1
* Clean every 2 weeks and replace every 6-12 months
C1-1—Main Brush Cover
C1-2—Latches
C1-3—Main Brush
C1-4—Main Brush Caps
C1-5—Main Brush Bearing
C1-6—Turn over the robot and press the
latches to remove the main brush cover.
C1-7—Pull out the main brush and remove
the main brush bearing.
C1-8—Rotate the main brush caps in
the indicated unlock direction to
remove the caps.
C1-9—After removing the tangled hair or
dirt at both ends of the main brush,
reinstall it, press on the main brush
cover to lock it in place. Make sure that
the main brush cover has been properly
attached. When properly installed, all
four tabs should be hidden.
Notes:
• Main brush should be wiped down with wet cloth and left to
dry away from direct sunlight.
• Do not use corrosive cleaning fluid or disinfectant to clean
the main brush.
Side Brush
C2
* Clean every month and replace every 3 to 6 months
1. Unscrew the side brush screw.
2. Remove and clean the side brush.
Reinstall the brush and tighten the screw.
Omni-Directional Wheel
C3
* Clean as needed
C3-1—Use a tool, such as a small screwdriver, to
pry out the axle and take out the wheel.
Note: The omni-directional wheel bracket cannot be removed.
C3-2—Rinse the wheel and the axle with
water to remove any hair and dirt.
Air-dry, reinstall, and press the wheel
and axle back in place.
Main Wheels
C4
* Clean every month
Clean the main wheels with a soft, dry cloth.
10
Dustbin and Washable Filter
C5
* Clean every week and filter should be replaced every 6-12
months.
C5-1—Open the upper cover of the robot
and take out the dustbin.
C5-2—Remove the washable filter and
empty the dustbin.
C5-3—Fill the dustbin with clean water.
Gently shake the dustbin, and then
pour out the dirty water.
Note: To prevent blockage, only use clean water without any
cleaning liquid.
C5-4—Rinse the washable filter repeatedly
and tap it to remove as much dirt as
possible.
Note: Do not touch the surface of the filter with your hands,
brush, or hard objects to avoid potential damage.
C5-5—Leave the dustbin and the washable
filter to dry and reinstall them.
Robot Sensors
C6
* Clean every month
Use a soft, dry cloth to wipe all sensors,
including:
C6-1—Dock Locator
C6-2—Wall Sensor
C6-3—Four Cliff Sensors