Roborock Q7 Manual Del Usuario página 9

Pause
Press any button to stop the robot during
operation. Press the button to resume
cleanup. Press the button to send the
robot back to the dock and end the current
cleanup.
Note: Placing a paused robot on the dock manually will end
the current cleanup.
Sleep
If the robot is paused for over 10 minutes,
it will go to sleep, and the power indicator
will flash every few seconds. Press any
button to wake it up.
Notes:
• The robot will not go to sleep when it is charging.
• The robot will automatically shut down if left in sleep mode
for more than 12 hours.
Charging
Automatically: After cleaning, the robot will
automatically return to the dock to charge.
Manually: In pause mode, press the
to send the robot back to the dock.
The power indicator light pulses during charging.
Note: If the robot fails to find the dock, it will automatically
return to its starting location. Place the robot on the dock
manually to recharge.
Error
If an error occurs while the robot is cleaning,
the power indicator will flash red and a voice
alert will sound. See "Errors" for solutions.
Notes:
• The robot will go to sleep automatically if left in an Error
state for over 10 minutes.
• Placing the robot on the dock in an Error state will stop the
current cleanup.
Spot Cleaning
Press and hold the
cleaning. Cleaning range: The robot cleans
a 1.5 m (4.9 ft) x 1.5 m (4.9 ft) square area
centered on itself.
Note: After spot cleaning, the robot will automatically return
to the starting point and enter Standby mode.
Resetting
If the robot does not respond when a
button is pressed or cannot be turned off,
reset the system. Press the Reset button,
and the robot will reset automatically.
Note: After resetting is complete, WiFi and other settings will
be restored to factory defaults.
Restoring Factory Settings
button
If the robot does not function properly after
a system reset, switch it on. Press and hold
the button and at the same time press
Reset button until you hear the "Restoring
factory settings" voice prompt. The robot
will then be restored to factory settings.
Do Not Disturb (DND) Mode
The default Do Not Disturb (DND) period is
from 22:00 to 08:00. You can use the app to
disable the DND mode or modify the DND
period. When DND mode is activated, the
robot will not automatically resume cleanup,
button to start spot
the power indicator light will dim, and the
volume of the voice prompts will lower.
Refilling the Water Tank or
Washing Mop Cloth
To add water or clean the mop cloth, press
any button to stop the robot and remove
the mopping module. After adding water
or cleaning the mop cloth, reinstall the
mopping module and press the
to continue.
App Features
Cleaning Map
• Multi-Map Management
• Real-Time Vacuum and Mop Route
• Map Zoning
• Map Editing
Custom Cleaning Modes
• Scheduled Cleaning
• Selective Room Cleaning
• Zone Cleaning
• No-Go Zones & Invisible Wall
• Custom Modes
• Carpet Boost
09
button