Publicidad
Idiomas disponibles
Idiomas disponibles
30/31
Unit with product-feed by pressure (hereinafter the Gun)
with Tip and Air Nozzle of the type described in the packaging.
Maximum air inlet pressure 8 bar (116 psi)
Maximum operating temperature of 60
Recommended working pressure may vary depending on the type of air cap used, but it could
be between 2 and 4 bar. (29 and 58 psi).
Air consumption according to Air cap Table.
Community directive:
ATEX Normative:
(*) Non electric gun in explosion hazard areas (ATEX) must have the earthing connections
and/or static-free feed hoses.
04. Components
1
Nozzle
2
Air Cap
3
Needle
4
Air distributor
5
Needle packing screw
6
Product regulator
7
Spray width regulator
8
Piston
9
Air valve
10
Quick connectors
05. Warnings
Before putting the unit into operation, and especially after each cleaning and/or repair operation,
a check must be made that the gun components are securely tightened and that the air and/or
product hoses are airtight (no air leaks). Faulty parts must be replaced or repaired as appropriate.
The gun is easy to handle thanks to its design and the simplicity of its mechanisms. No special
training is required for handling the gun. Use the gun according to the operating, maintenance
and safety instructions indicated in this manual and follow the application methods indicated to
obtain the required quality of finish.
Before putting the unit into operation, we recommend you to clean the gun as this has been
subjected to functional tests and before packaging it is treated internally with a protective coa-
ting, some of which may still remain. Apply thinner to eliminate this. Remove any residual grease
applied during assembly.
Ensure that the products to be applied are chemically compatible with the components these
come into contact with (aluminium, stainless steel, polythene and acetylene resin).
Do not use corrosive or abrasive products.
The gun has been designed for long service and can be used with the majority of the products
available on the market. Its use with highly aggressive products will quickly increase the need for
maintenance and spares. If you need to apply special products, please contact SAGOLA S.A.U.
o
o
C (140
F)
2014/34/UE
II 2G T4 x (*)
6
9
8
10
7
ENGLISH
5
3
1
4
2
Publicidad
