Health And Safety - Sagola V 4000 Manual De Instrucciones

15. Health and Safety

In order to carry out maintenance, repairs or cleaning, first disconnect the unit from the com-
pressed air distribution network.
We recommend using this unit in premises with forced ventilation and in accordance with the
current standards and provisions on the matter.
Near the unit, only keep the amount of product and thinner required for the work being done at
that time. After work has been completed, thinners and the product to be applied must be retur-
ned to their corresponding storage location.
Keep the working area clean and free of potentially dangerous waste (thinners, rags, etc...).
While work is in progress, there must not be any source of ignition (naked flames, lighted ciga-
rettes, etc.) in the working area as these might generate easily flammable gases. Likewise, the
approved protective means must be used in accordance with the regulations established in this
regard.
If the unit is used in an inadequate manner or its components are altered in any way severe
material damage may occur and bodily harm may be caused to the operator, other personnel
and/or animals and may even cause death. SAGOLA S.A.U. accepts no responsibility in for any
damage caused through the incorrect use of the unit.
Always use approved breathing units in accordance with current Standards and Regulations in order to
protect yourself from emissions produced during application.
Never exceed the maximum air inlet pressure (8 bar). Excessive pressure will cause greater
environmental contamination. To provide the hose with compressed air for the airbrush, fit a
pressure regulator.
As a general, preventive measure we advise you to wear goggles in accordance with the specific
environmental regulations and characteristics for the work centre.
Wear gloves when handling the product (see the manufacturer's recommendations) and clean the gun.
If, when the gun is in use, the ambient noise level exceeds 85 dB (A) the use of approved ear protectors
is required.
The gun in itself does not propitiate any mechanical risk of perforations, impact or pinching,
except those deriving from incorrect installations and handling.
While work is in progress, no vibrations are transmitted from the gun to any part of the body of
the operator and reaction forces are minimal.
Use Sagola antistatic hoses to eliminate possible electrical dischar-
ges that might create the risk of fire or explosion.
Pay adequate attention when handling the gun in order to prevent any damage that might lead
to dangerous situations for the user or personnel standing near the unit, as a consequence of
leaks, breakages, etc.
Do not use it if your mental capacity, perceptions and reactions are altered due to substances
such as alcohol, drugs, medicines, etc., or by tiredness or for any other reason.
ENGLISH