Start-Up; Add Device; Direct Pairing - HomeMatic IP HmIP-WTH-B-2 Manual De Instalacion Y Uso

Start-up

5 Start-up
5.1

Add Device

Read this entire section before starting the pairing procedure.
You can either connect the wall thermostat directly with one or more
Homematic IP devices or add the device to the Homematic IP Access
Point (HmIP-HAP). After direct pairing, configuration has to be done
directly on the device. After adding to the Access Point, configuration is
done via the Homematic IP smartphone app.
5.1.1

Direct pairing

You can connect the Homematic IP Wall Thermostat to a
Homematic IP Floor Heating Actuator (HmIP-FALx-Cx, HmIP-
FALMOT-Cx), a Homematic IP Radiator Thermostat – basic (HmIP-
eTRV-B/HmIP-eTRV-B-2) or a Home-matic IP Window- and Door
Contact with magnet (HmIP-SWDM/ HmIP-SWDM-2).
Please make sure you maintain a distance of at least 50 cm between
the devices.
You can cancel the pairing procedure by briefly pressing the system
button (C) again. This will be indicated by the device LED (C) lighting
up red.
The device LED (C) lights up green to indicate that pairing has been
successful. If pairing failed, the device LED lights up red. Please try
again.
If no pairing operations are carried out, pairing mode is exited
automatically after 3 seconds.
If you want to add another device to an existing device group, first
activate the pairing mode of the existing device in the group and
afterwards the pairing mode of the new device.
40