Pairing To The Homematic Ip Access Point (Alternative) - HomeMatic IP HmIP-WTH-B-2 Manual De Instalacion Y Uso

Start-up
Press and hold down the system button (C) for at least 4 seconds
•
to activate the pairing mode. The device LED (C) starts to flash
orange (see fig. 5). Pairing mode remains activated for 3 minutes.
• Press and hold down the system button of the device you want
to connect (e.g. the radiator thermostat – basic) for at least 4
seconds to activate the pairing mode. The device LED starts to
flash orange. For further information, please refer to the operating
manual of the corresponding device.
• If pairing was successful, the LED lights up green.
5.1.2

Pairing to the Homematic IP Access Point (alternative)

You can connect the device either to the Homematic IP Access Point
or the Central Control Unit CCU3. For detailed information, refer to the
Homematic IP User Guide, available for download in the download
area of www.homematic-ip.com.
First set up your Homematic IP Access Point via the Homematic IP
app to enable operation of other Homematic IP devices within your
system. For further information, refer to the operating manual of the
Access Point.
After pairing the wall thermostat to the Homematic IP Access Point,
the menu of the wall thermostat will be hidden and settings can be
adjusted only via the Homematic IP app.
To integrate the wall thermostat into your system and to enable control
via the Homematic IP app, you must add the device to your Homematic
IP Access Point first. To do this, please proceed as follows:
• Open the Homematic IP app on your smartphone.
• Select the menu item "Add device"(see figure 6).
• Open the battery compartment (G) using a slotted screwdriver to
loosen the wall mounting plate (see figure 3).
• Remove the insulation strip from the battery compartment of the
wall thermostat.
• Pairing mode remains activated for 3 minutes.
42