Allen Sports QR520-EB Manual De Instrucciones página 2

C.
INSTALLING RACK ONTO VEHICLE:
THIS RACK SHOULD ONLY BE USED ON CLASS III OR IV 2" RECEIVER
HITCHES PROFESSIONALLY INSTALLED ON AUTOMOBILES. NEVER USE
THIS RACK ON A TRAILER OF ANY KIND.
STEP 1: INSERT KEY INTO LOCK AND TURN KEY
COUNTER-CLOCKWISE SO THAT LOCKING KNOB CAN
TIGHTEN/ LOOSEN THE HITCH INSERT WEDGE.
STEP 2: ROTATE LOCKING KNOB COUNTER CLOCKWISE
TO LOOSEN THE HITCH INSERT WEDGE.
STEP 3: DEPRESS HITCH SPRING PIN AND INSERT
RACK INTO RECEIVER HITCH UNTIL HITCH SPRING PIN
ENGAGES HOLE IN VEHICLE RECEIVER HITCH
STEP 4: TURN THE LOCKING KNOB CLOCKWISE TO
TIGHTEN THE RACK INSIDE OF THE RECEIVER HITCH.
BE CAREFUL NOT TO OVER TIGHTEN; A PROPERLY
SECURED RACK SHOULD BE FREE OF ANY MOVEMENT
INSIDE OF THE RECEIVER HITCH.
STEP 5 (OPTIONAL): INSERT KEY AND ROTATE
CLOCKWISE TO THAT LOCKING KNOB CAN SPIN FREELY.
THIS WILL LOCK YOUR RACK TO YOUR VEHICLE.
TO REMOVE RACK FROM VEHICLE, FOLLOW STEPS 1
THROUGH 3 ABOVE.
D.
FOLDING UP CARRY ARMS:
• TO FOLD UP CARRY ARMS,
SQUEEZE TOGETHER THE
TWO RED TABS ON THE BACK
OF THE CARRY ARM ASSEMBLY,
AND SWING CARRY ARMS INTO
UPRIGHT POSITION.
1. SQUEEZE
RED TABS
• THE PINS CONNECTED TO THESE
TABS SHOULD "SNAP" INTO PLACE
TO HOLD THE CARRY ARMS IN AN
UPRIGHT POSITION.
• REVERSING THIS PROCESS WILL
KEEP THE CARRY ARMS LOCKED
IN A DOWN POSITION.
• IF BOTH PINS ON YOUR RACK
DO NOT PROPERLY ENGAGE
THE CARRY ARMS IN THE
UPRIGHT POSITION, DO NOT
USE YOUR RACK, AND CONTACT
R. A. ALLEN CO..
E.
LOADING BICYCLES ON RACK:
• REMOVE ALL LOOSE ITEMS FROM BICYCLES (PUMPS, BAGS, ETC.), AND CHECK THAT ALL QUICK RELEASE HUBS ARE TIGHT.
• LOAD FIRST BICYCLE WITH ITS CHAIN AND GEARS FACING AWAY FROM RACK. MAKE SURE THAT BICYCLES DO NOT COME IN
CONTACT WITH VEHICLE.
• LOAD SUBSEQUENT BICYCLES IN ALTERNATING DIRECTIONS. FOR BEST WEIGHT DISTRIBUTION, LOAD HEAVIEST BICYCLES
FIRST, WITH LIGHTER BICYCLES ON THE OUTSIDE. ADD PADDING BETWEEN BICYCLE CONTACT POINTS, IF NECESSARY.
• AFTER BICYCLES ARE LOADED, CHECK THAT ENTIRE RACK IS SECURE AND THAT NO-WOBBLE BOLT IS TIGHT, AND THAT THE
ROTATE KEY TO LOCK/
UNLOCK KNOB
RACK IS STILL FIRMLY IN PLACE. VISION OUT OF REAR WINDOW MAY BE RESTRICTED—USE SIDE MIRRORS ACCORDINGLY
WHEN BACKING UP.
CLOCKWISE TO LOCK
SPECIAL NOTE ON INSTALLING WOMEN'S STYLE FRAMES:
COUNTER CLOCKWISE
TO UNLOCK
PLACE ONE CARRY ARM UNDER FRONT TOP TUBE. WITH THE OTHER CARRY ARM, ROTATE TIE-DOWN CRADLE, AND
PLACE CARRY IN SPACE BEHIND SEAT TUBE AND BELOW REAR DOWN-STAY. THE ALLEN 900B ADAPTOR BAR IS ALSO
ROTATE KNOB
RECOMMENDED FOR THIS APPLICATION.
COUNTER CLOCKWISE
TO LOOSEN HITCH WEDGE
F.
SECURING BIKES TO RACK:
HITCH
INSERT WEDGE
SPRING
PIN
ALLEN LIFETIME WARRANTY:
IF AN ALLEN BIKE RACK IS FOUND TO HAVE A DEFECT IN
2.
WORKMANSHIP OR MATERIAL OVER THE LIFETIME OF THE
ROTATE ARMS
INTO UPRIGHT
ORIGINAL PURCHASER, ALLEN WILL REPAIR OR REPLACE
POSITION
THE RACK FREE OF CHARGE. THE WARRANTY DOES NOT
COVER DAMAGE OR WEAR WHICH OCCURS AS A RESULT OF
DAY TO DAY USE OR GENERAL WEAR AND TEAR.
Get the lastest news, info,
give-a-ways and pics on
our social media sites!
1.PLACE BICYCLE IN CRADLE.
3. USE 70" STRAP TO PULL
ALL BICYCLES TOGETHER
AROUND BOTTOM BRACK-
ETS. STRAP SHOULD ALSO
SECURE WHEELS.
/AllenSportsUSA @AllenSportsUSA
ALL BIKES MUST BE SECURELY TIED TO RACK. USE INDIVIDUAL TIE-DOWN STRAPS, OR
ADDITIONAL STRAPS IF NECESSARY.
2. LOCK DOWN TIE-DOWN STRAP.
R. A. ALLEN COMPANY, INC.
R. A. ALLEN CO., INC.—ALLEN SPORTS USA 36
505 BEACHLAND BLVD.
MAPLEWOOD AVE
SUITE 1, #1002
PORTSMOUTH, NH 03801, USA
VERO BEACH, FL 32963 USA
CUSTOMERSERVICE@ALLENSPORTSUSA.COM
CUSTOMERSERVICE@ALLEN.BIKE
WWW.ALLEN.BIKE
WWW.ALLENSPORTSUSA.COM
©2021 R. A. ALLEN CO., INC., ALL RIGHTS RESERVED
©2018 R. A. ALLEN CO., INC., ALL RIGHTS RESERVED
@AllenSportsUSA
ENGLISH - PAGE 2
For More
Product Info &
List of Dealers
Scan Our QR Code
V.2.18
V.8.20