WARNING!
• Do not use heating grade pellets. Use only cooking grade pellets manufactured of 100%
natural wood that is intended for pellet grill usage.
• We recommended using pellets with the following specifications: 8,000-8,500 BTU/LB
with ash content less than 1%.
• Do not use pellet fuel labeled as having additives.
• Never put wood chips or chunks into the hopper.
• Only use dry pellets. If the grill was stored with the hopper full, check the pellets to
ensure that they are completely dry before use. Hardwood pellets can absorb moisture
in wet or humid environments, causing them to expand and possibly obstruct or jam the
auger system.
• Never allow the hopper to empty while the grill is in operation. Make sure to fill the pellet
hopper with enough pellets before use or refill the pellet hopper as necessary.
CAUTION: ELECTRICAL COMPONENTS
• Disconnect the electric power before servicing. Do not attempt to clean or repair the grill
while it is connected to an electricity source.
• The external electrical power source used for this appliance must be electrically
grounded in accordance with local codes.
• Check the plug receptable before use. Do not plug in the grill if it is damaged.
• Make sure that the power cord does not contact with any hot surfaces.
• Do not cut or remove the grounding prong from the plug. Only use a GFCI protected
circuit to power the grill.
• High voltage used to power the grill can cause electric shock, or even death. Do not
immerse any electronic or heating element in liquid. Do not use near any source of
water or in the rain.
• When unplugging the grill, never pull from the cord. Always pull from the plug itself.
CAUTION: Do not install or use grill within 36 in (91.44 cm) of combustible materials
from back and sides of grill. Grill shall not be located under overhead surfaces (closed
carport, garage, porch, patio) that can catch fire.
Important Safety Information
5