Publicidad
Idiomas disponibles
Idiomas disponibles
THE HEATER REMAINS BURNING LOW
¼ Wick position too low.
Reinstall the wick height lock (Section F)
¼ Before you refilled the tank, the heater had burnt up almost all the fuel.
After having refilled, wait for 30 minutes before igniting the heater.
¼ You are using the incorrect type of fuel.
Refer to THE RIGHT FUEL (Section 'What you need to know in advance').
¼ The room is insufficiently ventilated.
Leave a window or a door wide open for a while.
THE HEATER BURNS TOO HIGH, THE FLAMES CANNOT BE ADJUSTED.
¼ You are using an incorrect, too volatile type of fuel.
Refer to THE RIGHT FUEL (Section 'What you need to know in advance').
¼ Wick position too high.
Reinstall the wick height lock (Section F).
H
MAINTENANCE
Your heater needs hardly any maintenance. It is, however, important that you
remove dust and stains in time with a damp cloth, because otherwise these
may cause stains that are hard to remove. Under normal conditions, only 3
components are subject to wear:
1. THE BATTERIES
You may replace the batteries yourself. Check the spark discharge sound. If the
sound is cracked, the voltage of the battery is low. Please change the battery.
Check the ignition plug following the maintenance procedure 3 if the sound
does not change even after the replacement of the battery. Do not dispose of
old batteries along with the other domestic waste. Follow the locally applicable
regulations regarding the disposal of domestic chemical waste.
2. THE WICK
To extend the glass fibre wick life, you must occasionally let the heater burn
until the tank is completely emptied and the heater extinguishes by itself. Do
this when you notice that the flame is weakening. The burn-out will cause some
smells, so it is recommended that you take the heater outside of the living room.
3. THE ELECTRODES
When the electrodes gets dirty by carbon or tar, clean the electrodes. If the
electrodes digs into the wick, it may cause the ignition failure. Then fix the
position of the electrodes. Be sure not to spill the water on the electrodes.
!
Do not remove any heater components yourself. Always contact your dealer
for repairs.
!
Let the heater cool down first, before you start any maintenance or service
work.
!
For maintenance, wear gloves for your safety.
4
9
Publicidad
