Publicidad
Idiomas disponibles
Idiomas disponibles
NOTE: Make certain the top of the wick adjuster and the
top of primary air tube are the same height. If
they uneven, the flames tend to be uneven, too.
9
Tighten the four (4) wing nuts around the wick adjus-
ter.
10
Turn the wick adjuster knob to be sure the wick moves
smoothly up and down.
After replacing the wick, check the operation of the
automatic extinguisher by pushing down the safety
button.
Wick height on position (1) of the wick height lock
should be 8 mm when wick adjuster knob is turned
fully clockwise. Be sure to check.
NOTE: Remember always to start a new wick on posi-
tion (1) of the wick height lock.
NOTE: If the wick does not move smoothly and easily,
or wick height on position (1) of the wick height
lock is not in the range of 7-8 mm, do not use
the heater. Disassemble and repeat items 5
through 10.
NOTE: If any ragged edges appear on the top of the
wick, trim them with a scissors carefully. DO NOT
cut the body of the wick.
11
Replace the outer cover on the fuel tank and secure it
into position with three (3) screws. Replace batteries in
the battery holder. Be sure that the combustion cham-
ber is properly seated by moving the combustion cham-
ber handle left and right.
Once again, check the proper operation of the automa-
tic extinguisher.
NOTE: Before lighting a new wick for the first time,
turn the wick to its lowest position and allow
the wick to saturate with paraffin for about
thirty (30) minutes.
9
10b
8mm
11a
11c
4
13
10a
10c
11b
Publicidad
