Operation; Choke Control - Craftsman 247.88835 Manual Del Operador

Chute Assembly
Drift Cutter
Auger
Snow thrower controls and features are described below and illustrated
in Fig. 16.
SPEED SELECTOR LEVER
The speed selector lever is located in the right side of
the handle panel and is used to determine ground speed
and direction of travel.
Forward
There are six forward (F) speeds. Position one (1) is the
slowest and position six (6) is the fastest.
Reverse
There are two reverse (R) speeds. One (R1) is the slower
and two (R2) is the faster.
Craftsman Snow Throwers conform to the safety standard of the American National Standards Institute (ANSI).

OPERATION

Headlight
Fuel Tank
Fuel Cap
Oil Fill
Meets ANSI Safety Standards
Wheel Drive Control
Speed Selector Lever
Primer
Clean-Out Tool
Choke
Auger Housing
Throttle
Skid Shoe
Figure 16

CHOKE CONTROL

The choke control is found on the rear of the
engine and is activated by rotating the control
counter-clockwise. Activating the choke control
closes the choke plate on the carburetor and aids
in starting the engine.
KEY
The key is a safety device. It must be fully inserted
into the ignition in order for the engine to start.
Remove the key when the snow thrower is not in
use.
IMPORTANT: Do not turn the key in an attempt to
start the engine. Doing so may cause it to break.
13
Two Way Chute Pitch Control™
Auger Control
Wheel Steering Control
Chute Directional Control
Oil Filler
Cap/Dipstick
Fuel Fill
Cap
Key
Starter Handle
Oil Drain
Electric
Start
Button
Electric
Switch Box