Error Message List; Restoring Factory Settings - Esoteric Grandioso T1 Manual Del Usuario

Error message list

CLOCK!
The unit cannot synchronize with a clock signal.
e See "Clock sync" on page 24.
MOTOR ERR!
The motor driver detected a problem and stopped the motor.
e Press the play/stop (t/8) button to restart the platter.
e If this appears frequently, contact the store where you purchased
the unit.
OverCRNT!
The motor driver detected excessive current and forced the motor to
stop.
e Press the play/stop (t/8) button to restart the platter.
e If this appears frequently, contact the store where you purchased
the unit.
PLAT ERR!
The platter is not rotating.
The motor stopped for this reason.
e Press the play/stop (t/8) button to restart the platter.
e If this appears frequently, follow the procedures in "Installation"
on page 13 to reinstall the product.
START ERR!
A start-up error has occurred. The platter is taking a long time to
reach the set RPM speed.
e The message will disappear when the platter reaches the set
RPM speed.
e If this appears frequently, follow the procedures in "Installation"
on page 13 to reinstall the product.
ADJ ERR!
The platter is not rotating at the set RPM speed.
e The message will disappear when the platter reaches the set
RPM speed.
e If this appears frequently, follow the procedures in "Installation"
on page 13 to reinstall the product.

Restoring factory settings

Settings are retained even if the power plug is disconnected.
Follow these procedures to restore the factory default settings and
erase all changes in memory.
1
Turn the Grandioso T1 off.
If the power is on, press the POWER button on the power supply
unit to turn it off and wait for more than 30 seconds.
2
Press the POWER button while holding down
the SPEED button.
When "Setup CLR" (settings cleared) appears on the display, stop
pressing the SPEED button.
Note about condensation
If this product is brought from a cold outdoor environment into
a warm room, or the heater has just been turned on in the room
where it is located, for example, condensation might occur on
operating parts, resulting in improper operation. If this occurs,
leave the product on and wait one to two hours. This should
enable normal playback.
25