Descargar Imprimir esta página

Fuel Recommendations; Adding Fuel - Craftsman 247.887801 Manual Del Operador

Publicidad

Idiomas disponibles

Idiomas disponibles

3.
Align the holes in the chute base with the holes in the lower chute
and secure with the previously removed screws. See Figure 5.
Installing the Recoil Starter Handle
1.
Remove the eye bolt and handle knob from the manual bag.
2.
Place the eye bolt and handle knob on the upper handle as shown
in Figure 6. Do not fully tighten the hardware until instructed to do
so.
Recoil Starter Handle
Handle Knob
NOTE: The opening of the eye bolt should face toward the back of the
snow thrower.
3.
Slowly pull the recoil starter handle up towards the eye bolt.
4.
Slip the recoil starter rope into the eye bolt from the back side of
the snow thrower. See Figure 6.
5.
Securely tighten the eye bolt and handle knob.
Figure 5
Eye Bolt
Figure 6
ASSEMBLY
SET-UP

Fuel Recommendations

Use automotive gasoline (unleaded or low leaded to minimize combus-
tion chamber deposits) with a minimum of 87 octane. Gasoline with
up to 10% ethanol or 15% MTBE (Methyl Tertiary Butyl Ether) can be
used. Never use an oil/gasoline mixture or dirty gasoline. Avoid getting
dirt, dust, or water in the fuel tank. DO NOT use E85 gasoline.
Refuel in a well-ventilated area with the engine stopped. Do not
smoke or allow flames or sparks in the area where the engine is
refueled or where gasoline is stored.
Do not overfill the fuel tank. After refueling, make sure the tank
cap is closed properly and securely.
Be careful not to spill fuel when refueling. Spilled fuel or fuel vapor
may ignite. If any fuel is spilled, make sure the area is dry before
starting the engine.
Avoid repeated or prolonged contact with skin or breathing of vapor.

Adding Fuel

Use extreme care when handling gasoline. Gasoline is extremely
flammable and the vapors are explosive. Never fuel the machine
indoors or while the engine is hot or running. Extinguish cigarettes,
cigars, pipes and other sources of ignition.
Always keep hands and feet clear of equipment moving parts. Do not
use a pressurized starting fluid. Vapors are flammable.
1.
Remove the gas cap, check the fuel level and add fuel if necessary.
8
WARNING
WARNING

Publicidad

Solución de problemas

loading