Descargar Imprimir esta página

General Information; Additional Information - HACH LANGE 2100AN Manual Básico Del Usuario

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 101
Specification
Details
Resolution
Turbidity: 0.001 NTU/EBC
Nephelo: 0.01
Absorbance: 0.001 Abs
Transmittance: 0.1% T
Color: 1 CU
Repeatability
±1% of reading or 0.01 NTU, whichever is greater
(under reference conditions)
Response time
Signal averaging off: 6.8 seconds
Signal averaging on: 14 seconds (when
10 measurements are used to calculate the average)
Stabilization time
Ratio on: 30 minutes after start-up
Ratio off: 60 minutes after start-up
Reading modes
Manual or auto range, signal averaging on and
adjustable or off, Ratio on or off
Power requirement
115–230 VAC, 50/60 Hz (automatic power selection)
28 W maximum
Pollution
2; II
degree/installation
category
Protection Class
1
Operating conditions
Temperature: 0 to 40 °C (32 to 104 °F)
Relative humidity: 0–90% at 25 °C, 0–75% at 40 °C,
noncondensing
Altitude: 2000 m (6560 ft) maximum
Indoor use only
Storage conditions
–40 to 60 °C (–40 to 140 °F), instrument only
Printer
Built-in (thermal, 58-mm, up to 28 column)
Interface
RS232C serial interface by way of DB9 subminiature
D-shell connector for data output to computer or
printer, and data input (command). No handshaking.
4 English
All manuals and user guides at all-guides.com
Specification
Air purge
Sample cells
Sample requirements
Enclosure
Dimensions
Weight
Certification

General information

In no event will the manufacturer be liable for direct, indirect, special,
incidental or consequential damages resulting from any defect or
omission in this manual. The manufacturer reserves the right to make
changes in this manual and the products it describes at any time, without
notice or obligation. Revised editions are found on the manufacturer's
website.

Additional information

Additional information is available on the manufacturer's website.
Details
Dry nitrogen or instrument grade air (ANSI MC 11.1,
1975)
0.1 scfm at 69 kPa (10 psig); 138 kPa (20 psig)
maximum
1
Hose barb connection for
/
-inch tubing
8
Round cells 95 x 25 mm (3.74 x 1 in.) borosilicate
glass with rubber-lined screw caps
Note: Smaller sample cells (less than 25 mm) can be used
when a cell adapter is used.
25 mm sample cell: 20 mL minimum
0 to 95 °C (32 to 203 °F)
High-impact polycarbonate plastic
30.5 x 40 x 15.6 cm (12.0 x 15.7 x 6.1 in.)
3.8 kg (8.5 lb)
CE, cETLus

Publicidad

Solución de problemas

loading