Teac AI-303 Manual Del Usuario página 16

Bluetooth
1
Press the standby/on (¤) button to turn the unit on.
2
Press the SOURCE button one or more times to select
Bluetooth ( ).
This puts the unit into Bluetooth mode.
3
Pair or connect with another Bluetooth device.
Pairing with another Bluetooth device
The first time another Bluetooth device is used with this unit, they
must be paired.
To prepare this unit to pair, put it into Bluetooth mode and press
the SOURCE button or remote control
seconds. When this unit is ready to pair, its
After this unit enters pairing mode, pair with it (shown as AI-303) on
the other Bluetooth device. The indicator stops flashing and stays lit
when pairing completes and they are connected.
For details, refer to the operation manual of that Bluetooth device.
To connect with a Bluetooth device that has already been paired,
follow the connection procedures for that device.
o When pairing or connecting, devices should be within a few
meters of each other. If they are too far apart, pairing and con-
nection afterwards might become impossible.
o If you want to delete pairing data and initialize the Bluetooth cir-
cuit, press the SOURCE button or remote control
least 10 seconds. At this time, all input indicators will flash twice.
V ATTENTION
Regardless of the connection standby states of this unit and the
other Bluetooth device, if the Bluetooth indicator continues blinking
for a long time, turn off both this unit and the other device. Then,
restart them and conduct connection procedures again.
16
wireless technology (continued)
®
button for at least three
indicator flashes rapidly.
button for at