Setup And Operation; Initial Operation - auna Vertico Swing DAB Manual De Instrucciones

SETUP AND OPERATION

Initial operation

• Before using the device for the first time, make sure that the voltage
specified on the type plate of the mains adapter corresponds to the
voltage in your household. Use the supplied mains adapter to connect
the DAB radio to a mains socket.
Basic operation - first steps
• Connect the unit to the power supply and extend the telescopic antenna
fully. The radio switches to standby mode and "01/01/2020 00:00" is
shown on the display. Then briefly press the "MODE" button to switch
on the radio.
System settings
1. Press the "MENU" button to access the menu in any mode.
2. Press the "Forward" and "Backward" buttons on the unit or the "Up" or
"Down" buttons on the remote control to select the system settings,
then press the "OK" button to confirm.
Sleep mode
• The unit has a sleep timer function that switches the radio off after a
certain time if no action has been taken by then.
• Press the "Forward" button or "Backward" button to select "Sleep time
off" > "15" > "30" > "45" > "60" > "90" > "120" > "150" > "180" minutes, then
press the "OK" button to confirm.
Alarm
NOTE: Make sure that the correct time and date are set before setting an
alarm.
1. Press the "MENU" button and select "Alarm", "Alarm 1" is displayed.
Press the "OK" button to confirm the setting for alarm 1.
2. Press the "OK" button repeatedly to switch "Alarm 1" on or off.
3. Select the frequency of "Alarm 1", press the "OK" button and use the
"Forward" and "Backward" buttons on the unit (or the "Up" and "Down"
buttons on the remote control) to select the desired setting: "Daily" >
"Once" > "Weekends" > "Weekdays". Press the "OK" button to confirm
and you will return to the menu.
EN
31