Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
The functions printed in yellow; LOCK, RES, LIMITS and PRESET, are used in
conjunction with the SHIFT button. To enable these functions press the SHIFT button
first. The SET icon will appear on the bottom left corner, then press the button for
the required function.
SHIFT/
1
SET
MIN/
2
MAX/TIR
3
LOCK
+/-
4
RES
5
6
IN/mm
LIMITS
7
ON/OFF
8
9
HOLD
10
ZERO
6
Section 2 Functions
Dual function button used to enable the, Preset and the Limits
function. When enabled the SET (S) icon will be displayed on the
top left corner of the display.
Displays the minimum or maximum values captured during the
movement of the spindle while in the min/ max limits operation.
The TIR function displays the difference of the two readings. See
"Setting the Min/Max/TIR" on page 9.
The Lock mode prevents, intended or unintended, operator
modifications to the Settings. Press SHIFT/SET button followed by
pressing and holding the LOCK button to lock the indicator after setting
the other functions. Refer to "Lock Function Activation" page 11 below
for further instructions.
Plus/Minus sets the direction (polarity) of the reading
Resolution selection. Select the Unit (English or Metric). Press
the SHIFT/SET then the RES (Plus/Minus) button. Press the
RES button to scroll through choices Press the SHIFT/SET to
make the selection. Refer to "Resolution Selection" page 10 for
instructions.
Toggles the display between English or Metric units.
Press the SHIFT/SET button then press the LIMITS button to
enable the function. Refer to the section, "Setting the Limits"
on page 8.
Power button. Press and release to turn on, and Press and hold
for 3 seconds to turn off.
Press the HOLD button momentarily to capture a reading. The
captured reading will flash on and off. To disable press the
HOLD button.
Press and release the ZERO button and the display will zero. The
spindle must not be moved until the Zero Sequence has elapsed.
See "Zero Sequence" on page 7, instruction #7.
Publicidad
