Setting The Min/Max/Tir Function - Starrett 2900 Serie Manual Del Usuario

stop flashing.
11. Press the LIMITS button to use the go/no go
function. The display will flash unless the reading is
within the range that you set your limits to. The SET
icon will remain on. The MAX and MIN icons will stay
off as long as the reading is within the set limits. If the
measurement is beyond the set limits, the display will
flash and the MIN or MAX LIMIT icon will indicate the
direction the limit has been exceeded. To exit Press the
LIMITS button.
1 - To enter Max Limit mode.
Press
2 - To enter the Max value.
SHIT/SET
Press
Adjust the gauge using a reference surface (gage block) to the desired maximum value.
3 - To capture the maximum value;
SHIFT/SET
Press
Press
Press

2.2 Setting the MIN/MAX/TIR Function

The Min/Max/TIR (Total Indicator Reading or Run-out ) function measures the
minimum and the maximum values of a surface (usually rotating) and then calculates
the difference between them. (TIR),
Note: This function is only available with the advanced type indicators.
1. Select the units to be displayed.
2. Bring the indicator down to the part being measured, to a point that is around half
the travel of the indicator.
3. Lock in the indicator at this height.
Note: Care must be taken; to make sure the difference between the high and low
measurements are not outside of the travel of the indicator as setup. Either your low
measurement will be wrong or your high measurement might jam the spindle and
damage your indicator.
LIMITS
Button
Button
Button
LIMITS
Button
LIMITS
Button
The MAX LIMIT icon will appear.
The LIMIT icon start flashing.
The LIMIT icon will stop flashing.
The Indicator is now set up with a maximum
and minimum limit range.
To exit Limit mode when you have completed
your measurements.
ENGLISH
9