Setting Preset - Starrett 2900 Serie Manual Del Usuario

11 ABS
12 PRESET

2.0 Setting Preset

Note: This function is only available with the 6 button indicators. To set the value, follow
the steps below:
1. The values can be set to: +/-89.99998 inches or +/-
8999.998 mm.
2. Press and hold the ZERO/ABS button for 2 seconds to
activate the ABS mode. The ABS icon will appear in the
upper right corner of the LCD, Fig.3.
3. Press the SHIFT/SET followed by the PRESET button.
The SET and PRESET icons will appear in the bottom
left hand side of the LCD. The PRESET icon should be
flashing, Fig.4.
4. Press the SHIFT/SET button to cycle thru the plus/
minus sign, and each digit place. The flashing item
indicates that the item is ready to be SET/Changed, Fig.5.
5. Press the PRESET button to increment the digit value
from 1-9. Press the SHIFT/SET button to set the digit and
move to next digit.
6. To set a negative value press the PRESET button when
the plus/minus sign icon is flashing. Fig.5.
7. Repeat steps 4 and 5 until all the digits are SET.
8. Use the SHIFT/SET button to cycle through the digits
back to the PRESET icon.
9. To exit the PRESET function, Press the PRESET button
when the PRESET icon is flashing. The SET value will
remain displayed.
10. Press and hold the ZERO/ABS button to exit the Preset
function.
1 - To enter into Preset mode;
SHIFT/SET
Press
2 - To cycle from digit to digit and back to preset;
SHIFT/SET
Press
Enables the ABS mode. Press and hold for 2 seconds to activate
the ABS mode, Press and hold for 2 seconds to exit the ABS
mode.
Press the SHIFT/SET button then press the PRESET button to
enable the function. Refer to the section "Setting Preset".
Button
Button
Then
PRESET
Button
ENGLISH
7