Publicidad
Idiomas disponibles
Idiomas disponibles
30
0°
45°
d
d
3
If the incubator is not
prearranged for the installation
of the automatic egg turning
device, continue following the
instructions, otherwise go to
point 4. By using a drill with a 4
mm-diameter bit, centre the four
existing marks in the cabinet and
drill to a depth equalling about
10 mm.
4
Install and suitably lock the
various parts with the supplied
accessories. Make sure that you
tighten the four self-tapping
screws (d): as they start locking
the device against the wall of the
incubator cabinet, rotate them
only by 45° to prevent stripping
the screws and damaging their
thread.
Publicidad
