Publicidad
Idiomas disponibles
Idiomas disponibles
Smart 120 Mini Syner
3.5 TIG WELDING WITH MANUAL GAS CONTROL AND LIFT ARC.
3.5.1 INSTALLATION OF TIG WELDING PROCESS
Gala Gar, S.L. c/ Jaime Ferrán, 19 (Políg. Cogullada) | Tel.: (+34) 976 47 34 10 - 50014 ZARAGOZA |
Press the encoder for 5 seconds to switch between
processes (MMA, Pulsed MMA or TIG).
Select MMA process Pulsed
5"
Press the encoder to switch between the parameters to
be set.
Turn it to adjust the parameter.
For the MMA process, 5 parameterisation menus are
available: Amps, Hot Start, Arc Force and VRD.
WELDING CURRENT
Turn the encoder to set the desired output current.
(20 to 120 amps)
HOT START
To adjust the Hot Start percentage, press the encoder
until the icon has a white arrow underneath it.
Turn the encoder to set the desired percentage.
Press the encoder to save the parameter.
ARC FORCE
To adjust the Arc Force percentage press the encoder
until the icon has a white arrow underneath.
Turn the encoder to set the desired percentage.
Press the encoder to save the parameter.
PULSING FREQUENCY
Pulsing frequency setting in Hertz.
Turn the encoder to set the desired value.
Press the encoder to save the parameter.
VRD (Voltage Reduction Device)
To activate or deactivate the VRD function, press the
encoder until the icon has a white arrow underneath it.
Turn the encoder to set the desired value (ON/OFF).
Press the encoder to save the parameter.
20/49
M
www.galagar.com
Publicidad
